AR15 Flat top Upper 16" midlength For Sale
 

SOLD Want to sell an AR15 flat top upper with Stainless Steel barrel, flash hider, bayonette lug, chrome bolt and forged charge handle. Upper is LMT (Lewis Machine and Tool). Barrel is a Wilson Match grade with 1 to 8 twist and chambered for 5.56 NATO. This upper has never been fired and I am the original owner.
I will sell the complete upper including chrome bolt and forged charge handle for $450.00 shipped. If you want just the upper minus the bolt and charge handle I'll do $350.00 shipped. No FFL required I can ship right to you.

http://i78.photobucket.com/albums/j1...x/DSCF1381.jpg

http://i78.photobucket.com/albums/j1...x/DSCF1380.jpg

http://i78.photobucket.com/albums/j1...x/DSCF1379.jpg

Re: AR15 Flat top Upper 16" midlength For Sale
 

Has the headspacing been checked?

Re: AR15 Flat top Upper 16" midlength For Sale
 

I may have caused some confusion by listing this with a Wilson barrel. This upper was assembled by LMT and has been checked for proper tolerances. Most AR15 manufacturers use mostly Wilson, Shaw or Mike Rock barrel blanks. This barrel is identical to My Rock River barrel that has a Wilson barrel.
Hope this helps.

Re: AR15 Flat top Upper 16" midlength For Sale
 

If it is an LMT built upper, you can bet it's been headspaced...looks like a good deal for a top-quality complete (less rear sight)upper, folks.

Re: AR15 Flat top Upper 16" midlength For Sale
 

I wish I could, but the "evil bayonet lug and flash hider" prevents me

Re: AR15 Flat top Upper 16" midlength For Sale
 

Grind off the bayo lug and install a muzzle brake...good to go.

Re: AR15 Flat top Upper 16" midlength For Sale
 

any other non FFL guns for sale?

How much would it take to complete this gun?

Re: AR15 Flat top Upper 16" midlength For Sale
 

Get a stripped Superior S15 lower ($99) and a lower parts kit ($35) and a recoil setup / buttstock (M4 T6 - $99), and you are in business.

Re: AR15 Flat top Upper 16" midlength For Sale
 

you have to be experienced for assembly and calibration of this?

im an engineer by trade so i think not, but like to be cautious when it comes to a fire arm!

And are these parts easily obtained without FFL?

Re: AR15 Flat top Upper 16" midlength For Sale
 

The Superior lower I was talking about requires an FFL because it has a serial number on it -- it is "the gun" part of the gun.

It is possible to get a plain casting of a lower receiver that is NOT FFL required (check www.dsarms.com). However these castings must be milled / drilled. For a few more bucks you can get an "80%" casting that only needs drilling -- again, no FFL because there is no serial number. HOWEVER... homebuilt guns cannot transfer ownership because of the lack of a serial number.

You can download lower receiver assembly instructions at www.ar15.com. I did this and was able to assemble my AR-15 kit in just 30 minutes.

Re: AR15 Flat top Upper 16" midlength For Sale
 

doing my homework!

the odds i get my greencard in time and apply for FFL the shtf maybe to close for comfort!!!